Extricom EXRE-10, User Manual

Page: 24 / 74

The Extricom Access Points
Extricom APs have two connectors located on the side of the device and four LEDs located on the
top of the device.
LEDs
WLAN Connector
Power Connection
LEDs
WLAN Connector
Power Connection
Optional SMA Connectors
EXRP-20D Only
Figure 10. Extricom AP
Table 3 describes the Extricom Access Point connectors.
Table 3. Extricom AP Connectors
Connectors Description
Power
"
External power is not required for most
applications. Power is supplied through the
Ethernet (PoE).
In case of an external power requirement by the application,
use UL Listed LPS (Limited Power Source) or NEC Class
II adapter. Rating – Input: 90-240VAC 0.8A max. Output:
48VDC 0.56A max.
Use standard DC connector type. External diameter 5mm,
internal diameter 2.1mm with positive center tap.
-
Due to regulatory requirements and pending
certification process for the power supply
connector - external power supply should not be
used.
WLAN RJ-45 connector – used to connect the Extricom AP to the
Extricom switch. Power is provided by the Extricom switch
to the AP when directly connected to it.
Ext. Ant.
Reverse polarity SMA connector (external thread with
inner male pin) for External Antenna connection (EXRP-
20D only).
16 Installing the Extricom WLAN System