Extreme Networks ExtremeWare XOS 11.1, Manual

Page: 95 / 496

Extreme Discovery Protocol
ExtremeWare XOS 11.1 Concepts Guide
95
●
Transmit PDUs with errors
●
Switch PDUs received
●
VLAN PDUs received
●
Received PDUs with errors
To view EDP port information on the switch, use the following command:
show edp
The following is sample output from the show edp command (the screen display was interrupted in the
following sample):
EDP advert-interval :60 seconds
EDP holddown-interval :180 seconds
EDP enabled on ports :1:1 1:2 1:3 1:4 1:5 1:6 1:7 1:8 1:9 1:10 1:11
1:12 1:13 1:14 1:15 1:16 1:17 1:18 1:19 1:20 1:2
1 1:22
1:23 1:24 2:1 2:2 2:3 2:4 2:5 2:6 2:7 2:8 2:9
2:10 2:11 2:12 2:13 2:14 2:15 2:16 2:17 2:18 2:1
9 2:20
2:21 2:22 2:23 2:24 2:25 2:26 2:27 2:28 2:29 2:3
0 2:31
2:32 2:33 2:34 2:35 2:36 2:37 2:38 2:39 2:40 2:4
1 2:42
Additionally, you view EDP information by using the following command:
show edp port <ports> detail
The following is sample output from the
show edp ports 1:1 detail
command:
=============================================================================
Port 1:1: EDP is Enabled
Tx stats: sw-pdu-tx=2555 vlan-pdu-tx=1465 pdu-tx-err=0
Rx stats: sw-pdu-rx=2511 vlan-pdu-rx=2511 pdu-rx-err=0
Time of last transmit error: None
Time of last receive error: None
Remote-System: BD10K Age = 41
Remote-ID: 00:00:00:30:48:41:ed:97
Software version: 11.1.0.19
Remote-Port: 1:1
Port Type: Ethernet
Auto Negotiation: OFF
Flow Control: SYMMETRIC/ASYMMETRIC
Duplex Speed: Configured = HALF Actual = HALF
Port Speed (MB): Configured = ERROR Actual = 100 Mbps
Remote-Vlans:
test (4094) Age = 41
=============================================================================
To configure the advertisement interval and the timeout interval, use the following command:
configure edp advertisment-interval <timer> holddown-interval <timeout>
Refer to “Displaying Port Configuration Information” for information on displaying EDP status.