Extreme Networks ExtremeWare XOS 11.1, Manual

Page: 260 / 496

CLEARFlow
ExtremeWare XOS 11.1 Concepts Guide
260
QoS Profile
This action modifies an existing ACL rule to set the QoS profile for traffic that matches that rule.
To change the ACL to forward to QoS profile <QPx>, use the following syntax:
qosprofile <ACLRuleName> <QPx>
For example:
qosprofile acl_rule_1 QP3
Mirror
This action modifies an existing ACL rule to mirror traffic that matches that rule, or to stop mirroring
that traffic. The mirroring port must be enabled when mirroring on an ACL rule is turned on. This
could be configured earlier, or use the CLI action to execute CLI commands to configure mirroring at
the same time.
To change the ACL to mirror traffic, use the following syntax:
mirror [add|delete] <ACLRuleName>
For example (enabling mirroring from within CLEARFlow rule):
cli enable mirroring to port 7:4 tagged
mirror add acl_rule_1
SNMP Trap
This action sends an SNMP trap message to the trap server, with a configurable ID and message string,
when the rule is triggered.
The message is sent periodically with interval
<period>
seconds. If
<period>
is zero, or if this optional
parameter is not present, the message is sent only once when the rule is triggered. The interval must be
a multiple of the rule sampling/evaluation interval, or the value will be rounded down to a multiple of
the rule sampling/evaluation interval.
To send an SNMP trap, use the following syntax:
snmptrap <id> <message> <period>
Syslog
This action sends log messages to the ExtremeWare XOS EMS sever. The possible values for message
level are: DEBG, INFO, NOTI, WARN, ERRO, and CRIT.
The message is sent periodically with interval
<period>
seconds. If
<period>
is zero, or if this optional
parameter is not present, the message is sent only once when the rule is triggered. The interval must be
a multiple of the rule sampling/evaluation interval, or the value will be rounded down to a multiple of
the rule sampling/evaluation interval.
The messages are logged on both MSMs, so if the backup log is sent to the primary MSM, then the
primary MSM will have duplicate log messages.
To send a log message, use the following syntax:
syslog <message> <level> <period>