Extreme Networks ExtremeWare XOS 11.1, Manual

Page: 216 / 496

Quality of Service
ExtremeWare XOS 11.1 Concepts Guide
216
NOTE
On the BlackDiamond 10K switch, this command applies only to untagged packets. On the Aspen 8810 switch, this
command applies to all packets.
Verifying Physical and Logical Groupings
You can display QoS settings on the ports or VLANs.
NOTE
On the BlackDiamond 10K switch, the screen displays both ingress and egress QoS settings. The 10Gbps ports have
8 ingress queues, and the 1 Gbps ports have 2 ingress queues.(Refer to
“Bi-Directional Rate Shaping—
BlackDiamond 10K Switch Only” on page 221 for more information on ingress queues, or bi-directional rate
shaping.)
To verify settings on ports or VLANs, use the following command:
show ports {<port_list>} information {detail}
Aspen 8810 switch display. You display which QoS profile, if any, is configured on the Aspen 8810
switch using the
show ports <port_list> information detail
command. Following is a sample
output of this command for an Aspen 8810 switch:
Port: 8:1
Virtual-router: VR-Default
Type: EW
Random Early drop: Disabled
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Active
Link Counter: Up 1 time(s)
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default Protocol: ANY Match all protocols.
Trunking: Load sharing is not enabled.
EDP: Enabled
DLCS: Unsupported
lbDetect: Unsupported
Learning: Enabled
Flooding: Enabled
Jumbo: Disabled
BG QoS monitor: Unsupported
Egress Port Rate: No-limit
Broadcast Rate: No-limit
Multicast Rate: No-limit
Unknown Dest Mac Rate: No-limit
QoS Profile: Qp3 Configured by user
Ingress Rate Shaping : Unsupported