Extreme Networks Alpine 3802, Hardware Manual

Page: 255 / 352

Configuring I/O Modules
Extreme Networks Consolidated Hardware Guide 255
1 This measurement uses the Optical Modulation Amplitude (OMA) test method; the absolute difference between an optical power
logic level one and an optical power logic level zero.
2 This measurement includes the dispersive effects of the cable on the transmitter, known as Transmitted Dispersion Penalty
(TDP).
Table 78 describes the power specifications for the 10GLRi module.
LEDs
The 10GLRi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the 10GLRi module, see “I/O Module LEDs” on
page 277.
Software Requirements
The 10GLRi module requires that you load ExtremeWare 7.0 or later on the switch.
Augmented Command. The automatic interface configuration command now includes a keyword to
specify the 10 Gigabit Ethernet interface. To configure the automatic interface costs for 10 Mbps,
100 Mbps, 1 Gbps, and 10 Gbps interfaces, use the following command:
config ospf metric-table 10m <cost> 100m <cost> 1g <cost> 10g <cost>
Where
<cost>
specifies the interface cost.
The default cost settings for each interface are:
• 10 Mbps—10
•
100 Mbps—5
• 1 Gbps—4
• 10 Gbps—2
Maximum overload average
receive power 0.5 dB (average power)
Channel insertion loss 6.4 dB
Table 78: 10GLRi power specifications
Volts Amps Watts
2.5 0 0
3.3 11 36
5 17 85
Table 77: 10GLRi optical parameters (continued)
Parameter Value