Extreme Networks Alpine 3802, Hardware Manual

Page: 275 / 352

Configuring I/O Modules
Extreme Networks Consolidated Hardware Guide 275
NOTE
During the ATM module boot up, the Status and Diag LEDs may be incorrectly lit to solid green or solid
amber. The LEDs reflect their true state after approximately 30 seconds when the module has
completed its boot cycle.
For more information on ATM module LED activity, see “I/O Module LEDs” on page 277.
Service Ports
The ATM module is equipped with two front-panel service ports: one port is a DB-9 connector; the
other is a micro HD-15 connector (see Figure 139). Both ports are reserved for use only by Extreme
Networks technical support personnel for diagnostic purposes.
Figure 139: Showing the components and LEDs of the ATM module
Software Requirements
The ATM module requires that you run ExtremeWare 7.0 or later on both the MSM64i module and the
ATM module, BootROM 7.8 for the MSM64i module, and BootROM 1.18 for the ATM module.
For more information about the software requirements, ATM module features, and ATM module
configurations, see the ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide.
ATM_002
Ejector/injector
handle
Network interface ports
Four on OC-3 ATM module
Port status LED
(one per port)
Service ports
Module status LED
General Purpose Processor (GPP)
Module diagnostics LED
Captive
retaining screw
Network processors
and heat sinks