Extec I-C13 Impactor, Operating And Maintenance Manual

Page: 38 / 292

Page 28 Commissioning and Operation Ver: IC13-EN-10567
I-C13 Impactor
4.3 Starting Procedure
1. Turn on at main isolation switch (1) positioned in the hydraulic control box next to the
battery.
2. Set the speed control (2) to the No.1 position.
3. Turn the key (3) clockwise to the “ON” position. All lights will flash for several seconds.
4. Turn the key to the 'Start' position and hold until the engine starts.
5. Release key. Key will return to “ON” position.
6. Engine is now running at idling speed.
COLD START: When starting the machine in temperatures of 0°C or below, run all systems at
engine speed No.1 for 15 minutes to allow the hydraulic oil to reach working temperature. DO
NOT feed material into machine during this time. When this is done stop all systems, turn engine
speed switch to No.2 and restart all systems. DO NOT turn engine speed switch from position 1
to 2 while any systems are running. DO NOT operate systems contrary to these instructions.
Note: The machine MUST be level in both longitudinal and traverse planes and set up on
firm level ground before being operated. Failure to comply with this or any other
instructions in this manual may cause damage to the machine and may invalidate
any warranty.
4.4 Stopping the Machine
To stop the machine, it is ESSENTIAL that the following steps be followed in order to prevent
damage to the machine:
1. Stop feeding material into hopper.
2. Wait for all material to fully discharge from feeder, impactor and conveyor belts.
3. Shut down systems in following order using the "stop" buttons in electrical control box:
a. Feeder
Figure 4-4: Starting procedure
2
3
1