Extec I-C13 Impactor, Operating And Maintenance Manual

Page: 44 / 292

Page 34 Commissioning and Operation Ver: IC13-EN-10567
I-C13 Impactor
After following instructions on the previous page, use either the Remote Handset or Hard Wire
Drive to move machine to desired position.
Note: The Remote Handset must be fully recharged at regular intervals. Use the correct
instructions for your type of controller.
WARNING: Under NO circumstances try to move the machine when engine speed is
set at position No.2 or when ANY personnel are standing on the machine.
For safety reasons, it is essential to check all around machine for obstacles or personnel which
may be endangered by moving the machine.
When moving machine, ensure that it is only moved over firm ground suitable for carrying the
weight of the machine. Prior to operating the machine, it is ESSENTIAL that both tracks are in
contact with firm level ground to avoid excessive vibration or rocking of the machine. DO NOT
MOVE THE MACHINE ACROSS EXCESSIVELY SLOPING GROUND.
NOTE:
1. When operating the White Remote Handset, the yellow buttons are for forward
movement and the blue ones for reverse. (These correspond to direction indicator
stickers on the machine.)
2. When operating the Hard Wire Handset, the yellow buttons are for forward movement
and the blue ones for reverse. (These correspond to direction indicator stickers on the
machine.)
When the machine is moved to its desired operating position, prepare the I-C13 Impactor for
operation by following the procedures laid out in the following pages.
OR
1: Remote Handset
2: Plug in Hard Wire
Umbilical Socket
3: Hard Wire Handset
DE1007