Extec I-C13 Impactor, Operating And Maintenance Manual

Page: 75 / 292

Ver: IC13-EN-10567 Trouble Shooting Guide Page 65
I-C13 Impactor
Section 6 Trouble Shooting Guide
Below is a list of some of the common problems that might occur on your machine. If these
problems arise, carry out the checks listed.
PROBLEM SOLUTION
Engine losing power or hard to
start.
Check air filter isn’t blocked.
Check diesel filter and sediment bowl.
Engine won't start or keeps
shutting off.
Check that emergency stops are not pushed in.
Check water level in radiator.
Check fuel level.
Check that the batteries are charged and that the
terminals are tight.
Check oil pressure, temperature, battery and over-speed
warning lights on electrical control panel.
Crusher won't start. Check that "Crusher" button is "ON" in electrical box.
Check fuel level.
Check hydraulic oil level in tank.
Check that there are no hydraulic pipes leaking.
Check flywheel belt tension.
Check engine speed switch is at No.2 position.
Clean air filter, diesel filter & diesel sediment bowl.
Check control pressure. See “Checking Hydraulic
Pressure” on page 67.
Feeder not working. Check Webtec is fully open.
Check pressure on at 4 station manifold using 0 - 250 bar
pressure gauge. See “Checking 5 Station Manifold
Pressure” on page 67.
Machine "Rocking" excessively. Check flywheel alignment.
Check ground conditions are firm and level.
Check tracks are not slack. If they are see 5.6.3
Increasing The Track Tension on page 62.