user Programmable Features (cont’d)
This group of Installer Programmable Features are all accessed as a group in the second level of
features’ programming. These features have a direct affect upon the system’s operations related
to the installation and vehicle type
anD ShOuLD OnLy BE chanGED By thE inStaLLER!!!
Feature #1 - Remote Start activation From the whitE/BLuE wire
1 pulse
(press “
start
” 1 time to program)
- DEFauLt
2 pulses
(press “
start
” 2 times to program)
3 pulses
(press “
start
” 3 times to program)
4 pulses
(press “
start
” 4 times to programm)
This feature changes how the remote start feature is activated from the (-) activation input wire.
Feature #2 - PinK/whitE (iGn #2)wire Function
ignition
(press “
start
” 1 time to program)
- DEFauLt
accessory
(press “
start
” 2 times to program)
Starter
(press
“
start
” 3 times to program)
This feature changes the operation of the unit’s large PINK/WHITE output wire.
this feature
should only be programmed by the installer
.
Feature #3 - Engine Detection method
tachless hi
(press “
start
” 1 time to program)
- DEFauLt
tachless Lo
(press “
start
” 2 times to program)
tach wire
(press “
start
” 3 times to program)
Data tach
(press “
start
” 4 times to program)
crank Only
(press “
start
” 5 times
to program)
This feature selects the method in which the remote start monitors the engine’s running condition
in remote start mode.
“tachless hi”
sensitivity mode uses a preset crank time (see installer feature #7) and monitors
the vehicle’s voltage level to determine if the engine is running. This setting looks for a voltage
increase of 0.3v after cranking.
“tachless Lo”
sensitivity mode operates like the “Tachless Hi” setting but looks for a voltage
increase of 0.5v after cranking.
“tach wire”
Before this setting is programmed, refer to the “Violet/White wire” section of the
installation manual for proper wiring connection and the Tach Learn Procedure. It will crank the
engine for up to 3 seconds or until a tach signal is detected.
Feature #11 - Confirmation Chirps
Siren
+
horn
(press “
start
” 1 time to program)
Siren
Only
(press “
start
” 2 times to program)
- DEFauLt
On Demand (siren+horn)
(press “
start
” 3 times to program)
Off
(press “
start
” 4 times to program)
This feature selects whether the siren and/or horn give confirmation chirps
. Both
outputs will always sound when the alarm system is triggered or in panic mode.
nOtE: Both the siren and horn outputs must be connected for this feature to function.
Feature #12 - anti-carjacking
ignition Only
(press “
start
” 1 time to program)
Door Only
(press
“
start
” 2 times to program)
ig Door
(press “
start
” 3 times to program)
Off
(press “
start
” 4 times to program)
- DEFauLt
This selects between the 2 forms of anti-carjacking protection. Details on using anti-
carjacking protection are described on page 7.
installer Programmable Features
10
