LOw BattERy/LOw tEmP autOmatic StaRtinG
Other Remote Start Features
nOtE: temperature Related Features are Only available On EDP+ models.
This feature will automatically start the engine if the vehicle battery drops below 11 volts or the
interior temperature drops to 15 (or 32) degrees fahrenheit. You must activate these features each
time you park your car to use them. They can be activated with the following steps:
• Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds press the
valet switch twice. If there is a 2 second delay without additional valet button presses, the horn
will honk 3 times activating low voltage start mode.
• To activate low temp starting, enter low voltage start mode as described above but, before the
horn honks, press the valet switch 1 time (15 degrees) or 2 times (32 degrees) within 5 seconds.
The horn will honk to confirm your selection.
nOtE: when low temp start mode is activated, low voltage start is also activated. these
features will operate once every two hours until the ignition key is turned “On”.
tuRBO timER FEatuRE
Pit-StOP FEatuRE
This feature allows you to leave your engine running for making quick errands. To use this fea-
ture, have the engine running normally from the ignition switch and your foot off the brake pedal.
Press the Valet Switch twice; the parking lights will flash and the horn will chirp 5 times. Turn the
key off and the engine will remain running for the programmed run time.
manuaL tRanSmiSSiOn StaRtinG
Remote starting with a manual transmission requires a different installation method and
installer feature #11 must be turned on. Also, a setup procedure that ensures the transmission
was left in neutral must be performed each time you leave your vehicle and intend to use remote
start later. Make sure the system is in an “UNLOCKED” state then perform these steps:
1) With the car running, hold the brake pedal, apply the parking brake, release the brake pedal.
2) Use the transmitter as if you were activating remote start (default: press START twice). The
status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle.
4) LOCK the vehicle with the remote. The engine will shut down (unless turbo timer is on) and the
status light will flash every 2 seconds to indicate it is ready to be remote started.
nOtE: manual transmission setup will cancel if you enter the vehicle.
This is recommended for vehicles equipped with a turbocharger. It allows the engine to idle
after driving to cool the turbo. When this Installer Programmable Feature (#10) is enabled, the
system will automatically keep the engine running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the programmed
time (1, 2, or 3 minutes), and then automatically turn it off.
• The system may be locked while the engine is running. Turbo Timer can be prevented from
engaging, or “bypassed” if desired, by turning the engine off before engaging the parking brake.
SELEctinG mutE & auDiBLE mODES
To select between audible (default mode) and mute modes, open the controller case, remove
the battery and do one of the following:
• AUDIBLE MODE: Insert the battery without pressing the controller button
• MUTE MODE: Insert the battery while pressing the controller button. The green light above the
button will flash once, indicating that the controller is in mute mode. You will only receive visual
confirmations (flashing button light) for system functions.
2-way controller Options (RS-265-EDP+ Only)
4
