Excalibur RS-260-EDP, Operation Manual

Page: 11 / 16

Feature #4 - Gasoline Or Diesel Engine
Gasoline (press “ start ” 1 time to program) - DEFauLt
Diesel 15 Sec. Delay
(press “
start
” 2 times to program)
Diesel 20 Sec. Delay (press “ start ” 3 times to program)
Diesel 30 Sec. Delay (press “ start ” 4 times to program)
This feature changes the system’s timing of the ignition and starter output sequence for gas or
diesel engines. Gasoline: the starter output will occur 3 seconds after the ignitions turn on. When
in “Tachless” mode, the engine running status is determined 10 seconds after starting. Diesel:
the starter output will occur 15, 20, or 30 seconds after the ignitions turn on (allows for glow plug
warming). When in “Tachless” mode, the engine running status will be determined 40 seconds
after cranking.
“Data tach” mode operates just like the “Tach Wire” setting except it takes its reading from the
D2D data port instead of using the Violet/White wire. Before using, make sure this function is sup-
ported by the Databus Interface module.
“crank Only” AKA “blind start” is similar to the “Tachless” settings however, it only makes one
start attempt and does not monitor engine running conditions. This is useful for many “push-to-
start” vehicles.
Feature #7 - Starter cranking time
0.75 Second
(press “
start
” 1 time to program)
- DEFauLt
1.00 Second (press “ start ” 2 times to program)
1.5 Seconds (press “ start ” 3 times to program)
2.25 Seconds (press “ start ” 4 times to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode. If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 0.2 second with each attempt..
installer Programmable Features (cont’d)
Feature #5 - Satellite Port, Green wire Function
Dome Light Output (press “ start ” 1 time to program)
Start (press “ start ” 2 times to program) - DEFauLt
ignition Output
(press “
start
” 3 times to program)
accessory Output (press “ start ” 4 times to program)
Status (press “ start ” 5 times to program)
This determines the function of the Green wire on the satellite relay port. This output can be
programmed for different functions as needed.
Feature #6 Satellite Port, Blue wire Function
ignition
(press “
start
” 1 time to program)
Status / GwR (press “ start ” 2 times to program) - DEFauLt
Defrost Pulse (press “ start ” 3 times to program)
Pulse after Engine Off (press “ start ” 4 times to program)
horn (press “ start ” 5 times to program)
This determines the function of the Blue wire on the Blue satellite relay port.
The Status setting turns on briefly before the Ignition output and stays on during remote start
mode. The other pulse settings give a 0.8 second pulse under the selected condition. Defrost
Pulse will send a pulse after start only when the cabin temperature is below freezing. On non-
EDP+ models, this setting will always send a pulse after start.
11