Setup
89
27891EN-900-02 / Edition 02/2017
5. Use an Allen screwdriver to turn the clamping cone (
h
) all the way up.
Fig. 61: Inserting plastic guides for working width 200 mm (shoulder roller)
(here: with top for shoulder guide)
Fig. 62: Inserting plastic guides for working width 200 mm (shoulder roller)
(here: with top for shoulder guide, hopper)
6. Insert plastic guide (
a
) at an angle from above under the clamping cone.
Make sure that the sharp edges of the rollers do not damage the sealing
surfaces (
b
).
7. Tighten the clamping cone with the Allen screwdriver
HAND-TIGHT
.
NOTE
Premature wear:
›
Only tighten the clamping cone as much as necessary so that the plastic
guide seals. The stronger it is tightened, the faster the sealing surface of the
plastic guide will wear.
a
b
a
b