EWIKON HPS III, Operating Manual

Page: 20 / 144

20 HPS-III-Heißkanalsystem_Vorspann_BA_V-2-0_EN
Installation
5. Installation
The following information is intended to help you install the HPS III hot runner system. In addtion, the assembly staff has to
have the know-how required to install an HPS III hot runner system.
The described installation processes are examples for standard nozzles and standard systems.
Special systems may require different procedures! Please observe the instructions in the order specific documents.
5.1 Transport
This chapter describes how to transport a hot runner system without damaging it and how to ensure occupational safety for
the staff.
5.1.1 Safety information on transport
NOTE!
Inappropriate transport
Damage to the HPS III hot runner system.
•
Only specially trained staff is authorised to transport the HPS III hot runner system.
• Only use designated attachment points to attach lifting devices.
• Exercise greatest caution when transporting the HPS III hot runner system. Handle with care.
Pendular motion while lifting the hot runner systems with a lifting device (e.g. overhead crane)
Damage to the HPS III hot runner system and/or injection mould.
• Avoid pendular motions! Move HPS III hot runner system slowly and with care.
• When using the lifting device to connect heavy components avoid tilting while lifting and lowering.
WARNING! PPE
Suspended loads
Death and severe crushing of body or extremities.
• Keep clear of and do not pass under suspended loads.
• Keep clear of suspended loads while they are being transported.
• Do not touch lifting devices and lifting accessories while lifting the load.
• Only lift, transport and set down loads, if you have received appropriate training.
• Only use suitable and undamaged lifting devices and lifting accessories which
are checked regularly.
• Do not exceed the maximum load limit of lifting accessories.
Sharp edges and heavy components
• Cut injuries to body and extremities, mainly to the hands.
•
Crushing of fingers or hand.