EVS Synapse GFS100, Installation And Operation Manual

Page: 26 / 48

#EmbD1_Inp ~
#EmbD4_Inp With these settings you can select where the corresponding audio channels of
outputs B are coming from. In this card you can choose to get the audio from
the de-embedder of SDI input 1 (Demb-SDI1) or SDI input 2 (Demb-SDI2), the
embedder of the active input (Demb-Input, dependent on the current active
input), from the ADD-ON bus groups, or to mute the corresponding channel
(set to off). Defaults here are Off.
Note: With this card the ADD-ON bus can only be used to either embed audio
or de-embed audio. When one of the EmbXx_Inp settings is set to embed from
the ADD-ON bus, no audio will be de-embedded towards the bus anymore,
not for any of the channels.
#EmbD1_Inp_Ch ~
#EmbD4_Inp_Ch
(GFS110 only)
With these settings you can select which Channel of the selected input should
be embedded to the corresponding output channel. Can be any channel
between Ch_1 and Ch_16. Defaults for C1 till C4 are respectively Ch_13 till Ch_
16.
#EmbA1_Gain ~
#EmbD4_Gain
(GFS110 only)
Adjusts the gain for the corresponding audio channel between -60 and 12dB.
Everything below -999 dB means the audio will be muted.
#EmbA1_Phase ~
#EmbD4_Phase
(GFS110 only)
Adjusts the audio phase of the corresponding to 0 deg or 180 deg.
5.6. GPI Mode
Setting Description
GPI-Ctrl You can set the GPI to be triggered in a latching manner or in a non-latching
manner. Default for this is Latch.
18 | November 2021 | Issue 1.00.C