EVS Synapse GFS100, Installation And Operation Manual

Page: 18 / 48

#V_delay V-Delay setting allows adjustment of the vertical phase of the output
signal with respect to the selected reference input.
The V-Delay setting gives a delay in addition to the reference timing. For
example: if the V-Delay is set to 10 TV HD lines, the output signal will be
delayed by reference 10 TV HD lines. The signal is delayed
(advanced) with respect to the phase of the reference signal. The
available range is from 0 to a maximum of 1125 lines (dependent on I/O
format). The default setting is 0ln. The preset master for this is Out-Frmt,
hence the # prefix.
#H_delay The H-Delay setting allows adjustment of the Horizontal phase of the
output signal with respect to the selected reference input.
The H-Delay setting gives a delay in addition to the reference timing. For
example: if the H-Delay is set to 10 pixels, the output signal will be
delayed by reference 10 pixels. The signal is delayed (advanced)
with respect to the phase of the reference signal. The available range is
from 0 to a maximum of 5124 pixels (dependent on I/O format). The
default setting is 0px. The preset master for this is Out-Frmt, hence the #
prefix.
#Freeze_A Freeze enables the capture of one Video Field or Frame (depending on
the setting Freeze_Mode). The settings for Freeze are On or Off. The
default is Off.
Delay-Status It is possible to display (in the IODelayA and IODelayB) the processing
time of the card in the Status menu. This setting allows you to switch this
function On or Off (default).
Lock-Mode Lock-Mode determines whether the card is locked to its input input 1), to
the reference (Ref1 or Ref2) or freerun (not locked). Can also be set to
RefAuto. By default it is set to Ref1.
When set to RefAuto the card chooses ref1 as its source. Whenever ref1
fails, it will switch to ref 2 (only for SFR08 and SFR18 frames and only
when ref2 offers the same ref format as ref 1). When ref 1 is back up
again, it will only automatically switch back to ref 1 when ref 2 fails.
Ref-Type Sets the type of incoming reference. Can be either Bi-Level (default) or
Tri- Level.
P60-P50_Sync With this setting you can choose to synchronize each one frame or each
two frames. Default is One Frame. The two-frame-synchronize mode
only works for 720p60, 720p50, 1080p50 and 1080p60 standards.
ANC_BlankA With this setting you can Blank the vertical ancillary data only (V-Only),
blank the horizontal ancillary data only (H-only) or blank both vertical and
horizontal ancillary data (H_And_V). You can also choose to not blank any
data (Off), which is also default.
10 | November 2021 | Issue 1.00.C