IONPURE
®
G2 DISPLAY BOARD – IP-POWERDSP-G2
IP-POWERDSP-G2MAN Rev 1
Page 16 of 25
Op.hours
: hours in operation since the initial startup. Time is accrued only while
the Remote ON/OFF input of the power controller is closed.
Ic (VDC)
: estimated value of analog signal between terminals Ic+/Ic- of the
selected power controller.
Vm (VDC)
: estimated value of analog signal between terminals Vm+/Vm- of the
selected power controller.
Im (VDC)
: estimated value of analog signal between terminals Im+/Im- of the
selected power controller.
PAGE 4:
Figure 13: RUN Screen – Page 4
Board temp
: temperature in degrees Celsius of the selected power controller’s
heatsink. If this value is higher than 64±4
o
C, a high temperature alarm will
trigger.
Press ENTER to activate the cursor and use the UP or DOWN arrows to select
any of the following submenus:
SETUP
,
ALARMS
or
LOGS
. Press ENTER
again to access the selected option.
PAGE 5:
Figure 14: RUN Screen – Page 5
