IONPURE
®
G2 DISPLAY BOARD – IP-POWERDSP-G2
IP-POWERDSP-G2MAN Rev 1
Page 11 of 25
The G2 display will detect the selected current range upon startup and will limit the DC output
current setpoint (
A DC out
) to this range.
2.4.2
Unit ID Selection
A unique identification number/letter needs to be assigned to each power controller that is
connected to a G2 display so they can be recognized without conflicts. This is done via rotary
switch SW2 of the G2 Power Controller. Each SW2 position corresponds to a channel or
module (MD) identification number on the display board, as shown in Table 1.
Table 1: Unit ID Selection
SW2 Position
G2 Display Channel
0
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
A
11
B
12
C
13
D
14
E
15
F
16
If two or more power controllers are mistakenly set to the same SW2 position, the G2 display
will show “ADDRESS CONFLICT” for that channel.
