Evolve SHOWROOMS, Installation Manual

Page: 45 / 58

EVOLVE
evolvefurnituregroup.com • Page
45
Fine Tuning of Panel Mounted Overhead Storage Unit - ADA Compliant
The overhead storage units are factory assembled and inspected.
Tension of the door mechanism is adjusted in accordance with the
size and the weight of the door.
STEP 1: Properly adjust door mechanism will take over the door
and lift it as soon as the door bottom is moved about 3 1/2 to 4”
above the bottom of the shelf. Should there be the need to fine
tune the door mechanism, proceed as follows:
Ensure that the panel is leveled,m square and properly supported
to prevent twisting. Check that the unit is properly installed and
the assembly is square on the panel. Remove internal civers by
pushing two tabs (protruding through the bottom shelf) up, then
moving the bottom of the internal cover away from the side wall.
STEP 2: To reduce tension, move springs on both sides of the
unit onto the next pin, closer to the central pivot point of the
door arm.
STEP 3: Similarly, to increase the tension move springs on both
sides of the unit onto the next pin, farther away from the central
pivot point of the door arm.
STEP 4: Further adjustments may be done by disengaging
springs from the arm, sliding them forward into the larger open-
ing in the shelf and by reinserting the spring again at longer or
shorter position, as required.
STEP 5: Set both springs with hooks pointing toward the back of
the unit.
STEP 6: Measure the height of each spring to ensure that both
are exactly the same length (fine adjustment can be made by
turning the springs in or out).
Important: any spring adjustment must be done on both sides of
the overhead to prevent the door from twisting and jamming.
Check closing and opening door function as well as door lock. Rein-
stall the inner covers and ensure that the internal door mechanism
arm is not rubbing cover’s side.
1
5
4
2
3
INSTALLATION GUIDELINES