Evolve SHOWROOMS, Installation Manual

Page: 5 / 58

EVOLVE
evolvefurnituregroup.com • Page
5
Corner Connections - Variable Height Two-Way, Three-Way and Four-Way, Corner Posts
Parts List
1 Aluminum corner post
1, 2, 3 or 4 slotted posts of varying heights with levelling glide
(attached to aluminum corner post)
1, 2, 3 or 4 single clamps
Appropriate trim, 1 Top cap
Variable-Height Corner Posts are used to connect panels of dif-
ferent heights at a corner.
Always start the installation of panels at a corner.
STEP 1: Partially attach a slotted post to one end of the panel to
be
installed. Do this by engaging the down-hook at the bottom of
the
panel (above the raceway channel) over the up-hook on the slot-
ted post.
STEP 2: Attach the opposite end of this panel to the correspond-
ing face of the Variable-Height Corner Post by engaging the
down-hook at the bottom of the panel (above the raceway chan-
nel) over the up-hook on the slotted post. (The slotted post is
secured to the face of the Variable-Height Corner Post.)
STEP 3: Connect the top of the Variable-Height Corner Post to
the panel
by engaging the single clamp through the slotted post and into
the panel liner. Secure the single clamp by bolting it to the top of
the panel using two (2) 1/2” flat head screws.
STEP 4: Repeat the above procedure to attach the second, third
and fourth
panel to the Variable-Height Corner Post.
STEP 5: Snap the vertical corner trim pieces onto the corner
post. Start at the top and align corner trim with panel top cap.
STEP 6: Press fit the top cap down onto the top of the Variable-
Height Corner Post.
STEP 7: Reattach the panel top caps.
INSTALLATION GUIDELINES