Evolve SHOWROOMS, Installation Manual

Page: 4 / 58

EVOLVE
Page
4 •
evolvefurnituregroup.com
Corner Connections - Equal Height
Parts List
1 Aluminum corner post
1, 2, 3 or 4 slotted posts with leveling glide (attached to aluminum
corner post)
1, 2, 3 or 4 single clamps
Appropriate trim, 1 Top cap
Corner Posts are used to connect panels of equal height at a
corner.
45º and 60º posts are installed in the same manner.
Always start the installation of panels at a corner.
STEP 1: Partially attach a slotted post to one end of the panel to
be installed. Do this by engaging the down-hook at the bottom of
the panel (above the raceway channel) over the up-hook on the
slotted post.
STEP 2: Attach the opposite end of this panel to one face of the
Corner Post by engaging the down-hook at the bottom of the panel
(above the raceway channel) over the up-hook on the slotted post.
(The slotted post is secured to the face of the Corner Post.)
STEP 3: Connect the top of the Corner Post to the panel by
engaging the single clamp through the slotted post and into the
panel liner. Secure the single clamp by bolting it to the top of the
panel using two (2) quarter 20 1/2” flat head screws.
STEP 4: Repeat the above procedure to attach the second, third
and fourth panel to the Corner Post.
STEP 5: Add spacer clips.
STEP 6: Press fit the top cap down onto the top of the Corner
Post.
STEP 7: Reattach the panel tops caps.
INSTALLATION GUIDELINES