Evolve SHOWROOMS, Installation Manual

Page: 53 / 58

EVOLVE
evolvefurnituregroup.com • Page
53
Off Module Worksurface Bracket
STEP 1: Prior to installing the Off-Module Worksurface Bracket
(EVHOMB1), install adjoining worksurface at normal height from the
floor (23 slots up from the bottom of the connector post).
STEP 2: Install the Load Bar, purchased separately, at the same
height (23rd slot) as the neighboring worksurface support bracket.
STEP 3: Disengage the Load Bar from the bracket closest to the
corner and slide it back from the corner approx 2” to 3”.
STEP 4: Insert the corner bracket at the same slot height in the op-
posite side of the corner post.
STEP 5: Reengage the Load Bar.
STEP 6: Hook the off-module bracket into the Load Bar and allow it
to temporarily hang down.
STEP 7: Place the worksurface on the cantilever and the corner
bracket and loosely insert bolts into the worksurface through these
brackets.
STEP 8: Slide the off-module bracket into place and secure it into
the insert at the front of the worksurface.
STEP 9: Tighten all bolts.
INSTALLATION GUIDELINES