Evolve SHOWROOMS, Installation Manual

Page: 43 / 58

EVOLVE
evolvefurnituregroup.com • Page
43
Panel Mounted Overhead Storage Unit - ADA Compliant
Parts List
1 Overhead Storage Unit
Begin by ensuring that the panel is leveled and properly supported to prevent
twisting.
STEP 1:Insert top brackets with teeth facing down into panel slots. Tap down if neces-
sary until the bracket is completely engaged. Note that the teeth are offset. Ensure
that, if properly installed, the off- set brings both brackets closer to the centre of the
panel.
STEP 2: Insert the second pair of brackets with teeth facing up. Remove internal covers
by pushing two tabs (protruding through the bottom shelf) up, then moving the bot-
tom of the internal cover away from the side wall.
STEP 3: Hang the unit carefully onto the brackets as illustrated,while ensuring that the
threaded pins welded to the sides are firmly resting in bracket slots.
STEP 4: Secure the brackets by tightening the six acorn nuts. Check closing and open-
ing door function as well as the door lock. Make adjustments if necessary( see the
following pages for instructions how to fine tune door mechanism functions).
STEP 5: Install inner covers by inserting their top, flexible tabs into slots in the upper
section of both sides. Note: the covers are not handed.
STEP 6: Bring the bottom of the cover closer to the unit’s side wall. Gently push until
the cover’s bottom tabs “click” into two slots in the shelf.
Check functionality of the door; make sure that the internal door mech- anism arm is
not rubbing cover’s sides. make adjustment if necessary.
1
1
4
4
5
6
3
3
2
2
Up-Mount Overhead Storage Unit - ADA Compliant
Parts List
1 Overhead Storage Unit
1 Set of Up-Mount Cantilevers
STEP 1: Insert the Up-Mount Cantilever into the top slot on the panel. Note that
the teeth are offset. Ensure that the offset brings arms of both installed cantilevers
closer to the centre of the panel.
STEP 2: Loosen 4 acorn nuts securing shelf’s bottom to the side wall. Important: do
not remove the nuts! Only allow for about 0.080” gap.
STEP 3: Bring the unit over the cantilevers and lower it carefully down as illus- trat-
ed, while ensuring that the cantilever arms are resting on thread- ed pins, behind all
acorn nuts.
STEP 4: Ensure that the whole unit is properly seated, cantilever arms are fully
engaged in panel slots and tighten the 4 acorn nuts.
NOTE: In order to comply with ADA, the bottom shelf of the storage unit must not
be higher than 50” above the floor.
INSTALLATION GUIDELINES