Evolution Fury 6, Original Instructions Manual, Page: 26 / 32

www.evolutionfury.com 26
• Use the pin spanner (provided) to hold
the outer blade flange.
• Use the hex key (provided) to unscrew
the arbor screw.
(Fig. 29)
NOTE:
The arbor screw has a Left Hand
thread. Turn clockwise to undo and
counterclockwise to tighten.
• Remove the arbor screw, washer and
outer blade flange.
• Manually operate the Lower Blade Guard
and retract it fully up into the body of the
machine
• Remove the blade by withdrawing it
outwards to clear the end of the arbor and
then downwards and forwards away from
the machine.
NOTE: The 5mm blade slot at the lower
front of the Cutting Head (Fig. 30) provides
extra clearance when manoeuvring the
blade into or out of the machine.
To refit:
• Ensure that the blade is suitable for this
machine.
• Ensure that the direction of rotation arrow
on the blade matches the direction of
rotation arrow found on the machines Side
Blade Guard. The blade teeth should always
point downward at the front of the saw.
• Using the blade slot to provide maximum
clearance and access to the machine,
carefully and gently manoeuvre the blade
up into the machine and locate it on the
inner blade flange.
• Reinstall the outer blade flange, washer
and arbor screw.
• Hand tighten the assembly.
• Hold the outer blade flange with the pin
spanner.
• Tighten the arbor screw with the hex key.
• Check that the blade spins freely by
rotating it by hand.
• Close the Retractable Blade Guard
around the blade so the blade teeth are
completely covered.
• Re-connect the Retractable Blade Guard
Operating Lever to its service position
using the pivot screw.
• Check the installation, particularly for the
operation of all the safety guards.
CHECKING AND SETTING OF
BEVEL ANGLES
WARNING: Before making any adjustments
ensure that the machine is disconnected
from the power supply.
NOTE: While all angular settings have been
factory set, checking and adjustment may
be required as a consequence of normal
operational wear and tear.
Fig. 29
Fig. 30