www.evolutionfury.com
16
TO CONFIGURE THE FURY6 FOR USE AS
A MITRE SAW
WARNING:
Only carry out this procedure
with the machine disconnected from the
power source.
Caution:
The Fury6 has many built in safety
features and safety interlocks. It is important
that the following instructions, and those
found on the label attached to the machine
table are read, understood and acted
upon. Failure to carry out the configuration
procedure could result in damage to the
machine and/or injury to the operator.
• Loosen the table height adjustment
screw.
(Fig.4)
• Raise the table top to its upmost position
and tighten the height adjustment screw.
(Fig. 5)
• Slightly push down on the Cutting Head
Handle.
• Pull out the Cutting Head Latching Pin
and allow the Cutting Head to rise to its
upmost position.
(Fig. 6)
• Remove the Auxiliary Lower Blade Guard
and store safely for future use.
The
Fury6
is now ready to use as a
Mitre Saw. (Fig. 7)
Fig. 7
Fig. 4
Fig. 5
Fig. 6
Summary of Contents for Fury 6
Page 2: ...www evolutionfury com 2 03 GB...
Page 29: ...www evolutionfury com 29...
Page 30: ...www evolutionfury com 30...
Page 31: ...www evolutionfury com 31...