Evolution Fury 6, Original Instructions Manual, Page: 24 / 32

www.evolutionfury.com 24
NOTE: A workshop dust extraction device
can be connected to the extraction port
found at the rear of the machine if required.
2. Table Saw On/Off Switches (Fig. 24)
The On/Off Switch is a two (2) button
latching type. The buttons are located on the
Front Left Hand side of the Cutting Handle.
• Push the Green (I) button to start the motor.
• Push the Red (O) button to stop the motor.
3. Rip cutting
NOTE:
The Fury6 in Table Saw mode is
optimally suited for the cutting of thin sheet
material such as laminate flooring etc.
Rip cutting is cutting along the length of a
piece of material rather than across it.
Rip cutting should always be done with the
Rip Fence set to the desired width and on
the RH side of the machines table.
NOTE: Check that the Rip Fence is locked
in position and is parallel to the saw blade.
Check that the riving knife is properly
aligned with the saw blade.
When ripping small section material a Push
Stick should be used to feed/guide the final
300mm of the material past the blade. A
Push Stick should always be used when
making cuts of less than 300mm.
NOTE:
A Push Stick
(Fig. 25)
is provided
with the Fury6 and has a dedicated storage
position to the front of the machine.
We recommend that when not in use the
Push Stick is stored on the machine.
When ripping long boards or large panels
always use a remote work support or enlist
competent trained help.
Feed the workpiece through the saw
keeping it indexed against the Rip Fence.
Use smooth, steady pressure and employ a
Push Stick when necessary.
Hands should never be in line with the
blade.
MAINTENANCE AND ADJUSTMENTS
WARNING:
Ensure that the machine is
disconnected from the mains supply before
any maintenance tasks or adjustments are
attempted.
Cleaning
After each use the machine should be
cleaned. Remove all sawdust etc from the
visible parts of the machine with a vacuum
cleaner. A vacuum cleaner can also be
connected to the machine dust extraction
port at the rear of the machine. This should
remove debris from the inside of the
machine. Never use solvents to clean plastic
parts, as solvents can damage them. Clean
only with a soft slightly damp cloth.
Fig. 25
Fig. 24