EVO Gimbals EVO RAGE3, Manual

Page: 10 / 20

13 14
BALANCE ADJUSTMENT BALANCE ADJUSTMENT
Please make sure the camera is properly mounted and balanced, otherwise the stabilizer may fail
to start or operate normally. The balance status of the stabilizer will greatly affect the run time.
Level Adjustment on Tilt Axis
Loosen the thumb screw on the quick release plate
so that it can slide forward or backward.
Balance Adjustment on Tilt Axis
Loosen the thumb screw (rotate about 3 times); Adjust the Tilt
Axis until the camera can stay still with the lens facing up (i.e.
the camera stays still and vertical to the ground), complete
this step by tightening up thumb screw.
Balance Adjustment on Roll Axis
Loosen the thumb screw (rotate about 3 times);
Adjust the Roll Axis until the camera can stay still.
Complete this step by tightening up thumb screw.
Hold the horizontal arm on the Tilt Axis with one
hand and adjust the position of the camera to find a
level balance where the camera can stay still and
almost level with its lens facing to the front.
Complete this step by tightening up the camera
mounting thumb screw.