EVO Gimbals EVO RAGE3, Manual

Page: 16 / 20

25 26
CALIBRATION AND FIRMWARE UPGRADE CALIBRATION AND FIRMWARE UPGRADE
1. Power on the stabilizer and enter the standby mode, press menu, rotate the dial to “calibration” option, press
right to enter the option.
2. As seen below, conduct the six-side calibration following the 6 steps shown in the graphs, finish by pressing
any button to exit the menu.
a) Slight deviation is found in the tilt angle of the camera in level position after startup.
b) Slight deviation is found in the roll angle of the camera in level position after startup.
c) Frequent small angle correction is found when the camera is in level position while the
stabilizer stays still.
a) Slight deviation is still found in level position after the initialization of the stabilizer.
b) Stabilizer unused for a long time.
c) Too large temperature difference between operation environments.
Slight deviation is still found in the tilt or roll angle of the camera in level position after
the initialization and six—side calibration of the stabilizer.
Six—Side Calibration
STEP 1
STEP 2
STEP 3
1. Correctly install the batteries.
2. Hold the camera mounting plate with one hand, long press the power button to start up the stabilizer; Long
press the Mode button to enter the standby mode while holding the camera mounting plate through the whole
process in case of start—up failure.
If the angle deviation still persists after the calibration, please try again following the procedure.
When do you need to calibrate the stabilizer?
When…
Please calibrate the stabilizer when necessary to ensure normal use.
Start Up
Calibration
Conduct
Six-Side
Calibration
Fine tune
motor force
Start Up Calibration
How