evertz 570DSK-12G-F, User Manual

Page: 13 / 56

570DSK-12G-F
Keyer With Logo Insertion
Page 3
2. INSTALLATION
2.1. UNPACKING
Remove the equipment carefully from the box and look it over. Any error should be reported to your
supplier immediately. Save all the packing material after unpacking the equipment as this could be useful
in the future if it’s needed to return the unit for maintenance.
Check each item supplied for transit damage. Any damage should be reported in detail to your supplier.
You must state the serial number of the unit, which can be found on the rear of the frame. Check that
power cords supplied are suitable for your country and the equipment is compatible with your main (line)
voltage.
2.2. FRAME
The 570DSK-12G-F comes with a companion rear plate that occupies two slots on a 570FR (3RU) or
S570FR (1RU) frame. When installed in the 570FR frame, a “Blank Slot” must be installed next to the
module’s front panel.
2.3. POWER REQUIREMENTS
The 570FR/S570FR frame comes with one auto-ranging power supply that automatically senses the
input voltage over the range of 100 to 240 VAC. An additional power supply (570PS) can be ordered to
provide fully redundant powering of the frame. Power should be applied by connecting a 3-wire grounding
type power supply cord to the power entry module on the rear panel of each power supply. The power
cord should be minimum 18 AWG wire size; type SVT marked VW-1, maximum 2.5m in length.
The power entry modules contain a standard IEC power inlet connector, two 5 x 20 mm fuse holders and
an EMI line filter.
CAUTION – TO REDUCE THE RISK OF ELECTRICAL SHOCK, GROUNDING OF
THE GROUND PIN OF THE MAINS PLUG MUST BE MAINTAINED.
2.4. REFERENCE
The 570FR/S570FR frame comes with two BNC connectors, labeled as REF1 and REF2. There must be
an analog reference present to ensure that the sigal passing through 570DSK-12G-F will occur
synchronously.
The 570DSK-12G-F requires to receive bi-level reference (NTSC or PAL). Also, the signal sources need
to be of the same standard and frequency. These sources must lock to the same reference and be timed
to within ±1/2 line with respect to the reference as well.

NOTE: NTSC reference must be placed into REF1 port and PAL reference
must be placed into REF2 port.