TUTIS Series DVR
18
4.1.2
Alarm
In the Alarm Menu, you can configure the Alarm Settings and Event Settings including Motion
Detection, HDD Fail, Wrong Password and Video Loss.
4.1.2.1 Alarm In
【
Alarm Channel
】：
Select an alarm channel.
【
Sensor Type
】：
Select a wiring type of the alarm input: Normal Open or Normal Close.
【
Actions
】
Record: Select the desired channels for recording when an alarm is triggered.
Alarm Out: Select an alarm output channel for outputting the signal.
Buzzer: Check the box to enable the buzzer when an alarm is triggered.
E-Mail: Check the box to send email notification when an alarm is triggered. Email operation
requires valid email setup in the Network > Advanced menu.
Action PTZ: If PTZ cameras have been connected to the DVR. Click this button to configure the
preset positions of the PTZ cameras. The PTZ cameras will roll to the positions when an alarm
is triggered.
DISP-Video: Select a channel for displaying the channel in full-screen when an alarm is
triggered. You can select to display the channel on the Main monitor or Spot monitor. The
Spot monitor is only available for 16CH model.
【
Event Duration
】：
Set up a delay time after an alarm is triggered.
【
Copy To
】：
Applying the same settings to another alarm input channel. Select an alarm
channel or All and then click the
Copy
button.
Click
Apply
to apply the settings to the DVR, or click
OK
to save the settings and exit from the
current menu.