26
L
OADING
R
OUTING
C
ONFIGURATIONS
As was stated in the Overview, the H8000FW houses two separate DSP engines. DSP A
is always running a program and DSP B is always running another program
or
they
"combine their forces" to run one large program (monolithic mode). When using both
processors separately, the program running on DSP A does not necessarily have anything
to do with the program running on DSP B, and the program running on DSP B does not
necessarily have anything to do with the program running on DSP A! (The display can
only show the parameters for one of them at a time - use the
PROCESSOR A/B
key to
toggle between displays.)
When running "monolithic" programs, DSP B
effectively disappears. The monolithic program uses
the routing configuration for DSP A. When you are
done with the monolithic program and load DSP-
specific program, DSP B’s previous routings will be restored - it will "reappear." You can
identify monolithic programs in the
PROGRAM
area by a Roman Numeral "II" next to
their name (e.g.,
DynoMyPiano_Ambience
and
Piano & Vocal Halls
in this screen
shot).
While the functioning of DSP A is quite independent of DSP B and vice versa, we can
route
signals between them. Each DSP can accept eight input signals and produce eight
output signals. The signal routing between the various ins and outs and the two DSPs is
comprehensive and can be manually configured in just about any way imaginable.
However, for the purposes of this "Instant Gratification" section, we’ll stick to a sample
of the routing configurations that come as presets in the H8000FW. (Besides, you’ll
probably use these preset configurations most of the time because they cover the most
obvious and necessary routing configurations.)
→
To learn how to manually configure the routing configuration, see
The Comprehensive Input / Output
Scheme
on page 52.
To access the preset routing configurations, press and
hold down the
PROGRAM
key for one second to enter
the Routing Storage area. The LED next to the
PROGRAM
key will begin to blink and the upper right-
hand corner of the display will read "
Routings
." Use the
UP
and
DOWN
CURSOR
keys
to place the cursor over the routing configuration you would like to load and then press
SELECT
. Below, we describe many of the preset routing configurations in English and
complement that description with a block diagram. The routing configuration "name" as
Summary of Contents for H8000FW
