Eventide H8000FW, Operating Manual

Page: 13 / 206

7
DSP, press the
PROCESSOR A/B
key. If you load a "monolithic program" (indicated by a
roman numeral "II" next to its name), it will effectively load into DSP A, and DSP B will
disappear. If you load a "normal" program next, it will load into DSP A, and the "Thru'"
program will be loaded on DSP B.
→ See Program Load, Save, Delete, Etc. on page 118.
Press and hold this key for one second to access the Routing Storage area where "routing
configurations
"
are loaded and saved
.
→ See Signal Flow Example on page 68.
Press and hold this key again for one more second to access the Setup Storage area where
"setup configurations
"
are loaded and saved
.
→ See Storing and Loading Setups on page 142.
Press and hold this key again for one more second to access the Usergroup Storage area
where "usergroup
"
files may be renamed or deleted.
→ See Using User Groups to Organize Useful Programs on page 47.
→ See Miscellaneous Setup Options on page 144 to change the "one second hold time" required to enter
the above areas.
I)
PARAMETER/PATCH EDIT
Press this key briefly to access parameters for the
programs that are running. The parameters shown are for the program running on the
DSP referred to in the left-hand corner of the display ("
A
," "
B
," or nothing at all for
monolithic programs). To see the parameters for the program running on the other DSP,
press the
PROCESSOR A/B
key.
Press and hold the
PARAMETER
key for one second to access the Patch Editor. The
patch shown is for the program running on the DSP referred to in the left-hand corner of
the display ("
A
," "
B
," or nothing).
→ See the separate Programmer’s Manual for Patch Editor information.
→ See Miscellaneous Setup Options on page 144 to change the "one second hold time".
J)
SELECT
Press this key briefly to select something highlighted by the cursor or to load
a program on the PROGRAM screen.
Press and hold this key for one second to set up a remote control for whatever parameter
is highlighted on the display.