EVBox Iqon, Installation And Commissioning Manual, Page: 34 / 54

WARNING
Make sure that connection of the electrical power cannot occur during installation. Put up caution tape
and warning signs to mark the working areas. Make sure no unauthorized persons enter the working
areas.
4.4.1. Install the station
See the corresponding illustrations in manual B.
1. When Iqon is to be secured to a wall or back-to-back with another Iqon, remove two blanking
plates as follows:
Note: The two blanking plates must be removed to expose the locations for the brackets that are
used for wall and back-to-back mounting.
Note: For a back-to-back installation, you must also remove the two blanking plates from the
second Iqon.
a. When the charging cables are not retracted, retract the charging cables by pushing down the
levers in the cable locking mechanism.
b. Remove and retain two Torx T25 screws that secure the top blanking plate.
c. From the back of the station, remove and discard the top blanking plate.
d. Fully extend the charging cables and insert the safety pin.
e. Remove four Torx T25 screws that secure the transparent cover.
f. Remove and retain two Torx T25 screws that secure the bottom blanking plate.
g. From the back of the station, remove and discard the bottom blanking plate.
2. When required, install the 50 mm baseplate on the ground anchors.
3. Use the lifting equipment to lift the charging station onto the ground anchors.
WARNING: The charging station weighs 85 kg (188 lbs). Use only suitable lifting equipment
to move the charging station.
4. Install the protection shield.
Note: The protection shield prevents small parts falling in to the cable duct.
5. Install four washers and four nuts to secure the charging station.
6. For a wall-mounted Iqon, secure Iqon to the two brackets using four Torx T25 screws that you
EN
4. Installation instructions
30