EVBox Iqon, Installation And Commissioning Manual, Page: 33 / 54

3. Drill holes for the M12 ground anchors.
Note: Follow the manufacturer's instructions for the size and depth of the holes for the ground
anchors.
4. Install four M12 ground anchors.
4.3.2. Prepare wall mounting
See the corresponding illustrations in manual B.
As an option, a single Iqon can also be secured to a wall using two wall brackets. The Iqon must always
be secured to the ground (see Prepare ground anchors on page 29 ).
Note: The screws, washers and wall plugs or wall anchors are not supplied with Iqon. Use fasteners that
are suitable for the wall material.
1. Mark a center line vertically up the wall from the center of the baseplate.
2. Mark the position of the two wall brackets on the vertical line.
3. Drill two holes.
4. Insert a wall plug in each hole.
5. Secure the wall brackets with two washers and two bolts.
4.3.3. Unimi mounting
A Unimi mounting is a charging station mounting base that is pre-installed in the ground. An adapter
that is specific for Iqon is available for the Unimi mounting. No additional preparation is necessary.
Refer to the Unimi Installation Manual for all details of the Unimi mounting.
4.4. Install charging station
When the installation area is prepared you can then install and connect the charging station.
4. Installation instructions
EN
29