Eurotherm 590+ Series, Product Manual, Page: 127 / 308

Programming Your Application
6-17
590+ Series DC Digital Converter
CONFIGURE DRIVE (MMI only)
This MMI menu contains many of the parameters required for configuring the drive.
CONFIGURE ENABLE: The operation of the Block Diagram is suspended and all Operator
Station LEDs will flash whilst CONFIGURE ENABLE = TRUE.
Note: The CONFIGURE ENABLE parameter is also available in the following MMI menus
for ease of use:
CALIBRATION
CONFIGURE I/O
MMI Menu Map
1
CONFIGURE DRIVE
CONFIGURE ENABLE
NOM MOTOR VOLTS
ARMATURE
CURRENT
FIELD CURRENT
FLD.CTRL MODE
FLD.VOLTS RATIO
MAIN CURR. LIMIT
AUTOTUNE
SPEED FBK SELECT
ENCODER LINES
ENCODER RPM
ENCODER SIGN
SPD.INT.TIME
SPD.PROP.GAIN
Parameter Descriptions
CONFIGURE ENABLE Tag Number 39 Range: See below
Selects Parameterisation Mode (DISABLED) or Configuration Mode (ENABLED). Refer to
“Modifying a Block Diagram”, page 6-1.
0 : DISABLED
1 : ENABLED
NOM MOTOR VOLTS
Refer to CALIBRATION, page 6-14.
ARMATURE CURRENT
Refer to CALIBRATION, page 6-14.
FIELD CURRENT
Refer to CALIBRATION, page 6-14.
FLD. CTRL MODE
Refer to FIELD CONTROL, page 6-32.
FLD. VOLTS RATIO
Refer to FIELD CONTROL, page 6-32.
MAIN CURR. LIMIT
Refer to CURRENT LOOP, page 6-18.
AUTOTUNE
Refer to CURRENT LOOP, page 6-18.
SPEED FBK SELECT
Refer to SPEED LOOP, page 6-59.
ENCODER LINES
Refer to CALIBRATION, page 6-14.
ENCODER RPM
Refer to CALIBRATION, page 6-14.
ENCODER SIGN
Refer to SPEED LOOP, page 6-59.
SPD. INT. TIME
Refer to SPEED LOOP, page 6-59.
SPD. PROP. GAIN
Refer to SPEED LOOP, page 6-59.