Eurotherm 590+ Series, Product Manual, Page: 123 / 308

Programming Your Application
6-13
590+ Series DC Digital Converter
BLOCK DIAGRAM (MMI only)
The parameters in Block Diagram connect the outputs of RAISE/LOWER, RAMPS, SETPOINT
SUM 1, and the Special Blocks (MMI menu) functions to destinations as required. These
functions are only executed when the destinations are connected to a non-zero tag. If a function is
not required, set its destination tag to zero. This causes the processor to ignore the function and
reduces processor loading.
MMI Menu Map
1
SYSTEM
2
CONFIGURE I/O
3
BLOCK DIAGRAM
RAISE/LOWER DEST
RAMP O/P DEST
SPT SUM 1 DEST
PID O/P DEST
DIAMETER
TAPER
SETPOINT SUM 2
POS. I CLAMP
NEG. I CLAMP
TENS+COMP CALC.
Parameter Descriptions
RAISE/LOWER DEST Range: 0 to 549
Refer to RAISE/LOWER, page 6-50.
RAMP O/P DEST Range: 0 to 549
Refer to RAMPS, page 6-52.
SPT SUM 1 DEST
Range: 0 to 549
Refer to SETPOINT SUM 1, page 6-56.
PID O/P DEST Range: 0 to 549
Refer to PID, page 6-47.
DIAMETER Range: 0 to 549
Refer to DIAMETER CALC., page 6-27.
TAPER Range: 0 to 549
Refer to Error! Not a valid result for table. , page 6-72.
SETPOINT SUM 2 Range: 0 to 549
Refer to SETPOINT SUM 2, page 6-57.
POS. I CLAMP Range: 0 to 549
Refer to CURRENT LOOP, page 6-18.
NEG. I CLAMP Range: 0 to 549
Refer to CURRENT LOOP, page 6-18.
TENS+COMP CALC. Range: 0 to 549
Refer to TENS+COMP CALC., page 6-71.