Eurotherm 590+ Series, Product Manual, Page: 118 / 308

6-8
Programming Your Application
590+ Series DC Digital Converter
AUX I/O
The auxiliary I/O parameters are primarily
intended to extend the functionality of the
serial links by allowing them access to the
drive analog and digital terminals.
START, JOG and ENABLE from digital
input terminals C3, C4 and C5 respectively
connect directly to the AUX I/O block.
Output signals are then sent to the drive start
and drive enable logic and the JOG/SLACK
function block.
Aux I/O
–
START (C3) [ 68]
–
OFF
–
DIGITAL INPUT C4 [ 69]
–
OFF
– DIGITAL INPUT C5 [ 70] – OFF
–
SEQ STATUS [537]
–
0x0000
ON
–
[161] AUX START
–
ON
–
[227] AUX JOG
–
ON
–
[168] AUX ENABLE
–
OFF
–
[ 94] AUX DIGOUT 1
–
OFF
–
[ 95] AUX DIGOUT 2
–
OFF
–
[ 96] AUX DIGOUT 3
–
0.00 % – [128] ANOUT 1 –
0.00 %
–
[129] ANOUT 2
–
0x0000
–
[536] REM. SEQUENCE
–
FALSE
–
[535] REM. SEQ. ENABLE
–
OFF
–
[496] JOG/SLACK
–
OFF – [497] CURRENT CONTROL –
MMI Menu Map
1
SETUP PARAMETERS
2
AUX I/O
AUX START
AUX JOG
AUX ENABLE
AUX DIGOUT 1
AUX DIGOUT 2
AUX DIGOUT 3
ANOUT 1
ANOUT 2
JOG/SLACK
ENABLE
REM.SEQ.ENABLE
REM.SEQUENCE
SEQ STATUS
Parameter Descriptions
START (C3) Range: See below
Refer to the DIAGNOSTICS function block description, page 6-22.
0 : OFF
1 : ON
DIGITAL INPUT C4 Range: See below
Refer to the DIAGNOSTICS function block description, page 6-22.
0 : OFF
1 : ON
DIGITAL INPUT C5 Range: See below
Refer to the DIAGNOSTICS function block description, page 6-22.
0 : OFF
1 : ON
SEQ STATUS Range: 0x0000 to 0xFFFF
A status word that groups important system flags together for use by remote device over a
network. (Refer to “Remote Sequencing” below).
AUX START Range: See below
Software Start/Run command.
0 : OFF
1 : ON
AUX JOG Range: See below
Software Jog command.
0 : OFF
1 : ON
AUX ENABLE Range: See below
Software Enable command.
0 : OFF
1 : ON