Eurotech 930150-4003R, User Manual

Page: 88 / 120

ZyWAN-G9 - User Manual
88 110150-4002A
Chapter 8 Terminal Clients
The following screen capture shows the Terminal Clients tab.
The Terminal Client makes an outbound TCP/IP connection to a remote server, allowing pass-through
communication with a local serial port. Its serial port also provides AT command emulation to act
similar to a dial modem.
After setting all the
Terminal Clients properties, click the Submit New Configuration button before
switching to a new tab or closing the window.
Note:
Changes made to the Terminal Clients page take effect immediately after submitting
changes without requiring a reboot.
To allow one or more Terminal Client services to be configured, set
Enable Terminal Clients to Yes .
The Table of Terminal Clients is displayed, as shown in the following screen capture.
The following table lists the buttons available.
BUTTON
EXPLANATION
Insert Row#
Each of the Terminal Clients exists as a large set of properties in a
numbered table row. In order to insert a row in the table, enter a number in
the box between 1 and one greater than the highest number of rows. Then
click the
Insert Row# button to insert a blank row. This row must be filled in
with all data required.
Note that this table can get very large, with inner tables on each Terminal
Client table row. When adding or deleting a Terminal Client configuration,
make sure to click the
Insert Row# or Delete Row# buttons at the very
bottom of the main table.
Delete Row# In order to delete a Terminal Client configuration (a row in the main table),
enter a number in the box between 1 and the highest number of rows. Then
click the
Delete Row# button to delete the row. Once a row is deleted, it
cannot be restored without inserting a row and entering the data again.