Eurotech 930150-4003R, User Manual

Page: 34 / 120

ZyWAN-G9 - User Manual
34 110150-4002A
Initial Connection Over a Network
An alternate way to start the ZyWAN-G9 and to perform an initial configuration is to connect it to an
existing network which also contains the configuration computer (PC).
Note:
Ethernet port „0‟ is used in this section, which typically comes configured to obtain its
address automatically from a network using DHCP. In some cases, the ZyWAN-G9 may
come factory loaded with different user settings. These instructions may or may not apply,
depending on the customer configuration.
To connect the ZyWAN to an existing network which also contains the configuration computer,
complete the following instructions:
1. Connect ZyWAN-G9 to an existing Ethernet network and to the PC serial port.
2. Apply power to the ZyWAN-G9.
3. Determine ZyWAN-G9 network address.
4. Configure the ZyWAN-G9 via its Web page.
The following sections provide detailed explanations of these actions.
1. Connect ZyWAN to the Network
To connect ZyWAN to the network, complete the following steps:
1. Connect the null modem serial cable from the PC to COM1 of the ZyWAN-G9.
2. Connect the ZyWAN-G9 network port labelled
„0‟ to an existing network, using a standard
10base-T Ethernet cable as shown in the following diagram.
Configuration PC
ZyWAN
Network Hub or Switch
RS-232 null modem
serial cable
Note:
The PC must exist on the same network. Consult a network administrator for assistance, if
necessary.
2. Apply Power
Connect the power supply to a wall outlet and to the 4-position power connector on the ZyWAN-G9.
See
Power Connector on page 17 for the power input socket pin configuration details.