Troubleshooting
7 - 28 Operation
7
possible cause:
A software conflict made the system “crash”.
solution:
Consult your
OS
manual. As a last resort, since you will
lose any unsaved data, try to reboot the system or if that
doesn’t work, turn the computer off and on again.
The save-to-disk function does not work.
possible cause:
The system can’t access the Save to Disk partition.
indicator:
When you press the
Fn + F4 (Suspend) key
combination,
Standby is activated instead of Hibernate.
solution:
1.
Make sure you have enabled Hibernate in the Power
Management/Power Options control panel in your OS (
see
Chapter 3:“Conserving Power Throughout The Whole
System” on page 3-18)
.
2.
If in
Windows 98SE
, set up the Save to Disk partition if
you haven’t done so. (
see Chapter 4:“PH (Save To Disk -
Hibernate)” on page 4-18
)
3.
Run the PHDISK utility if you installed a different hard
disk with a Save to Disk partition on it, or there has been a
CMOS
or Checksum failure (
see Chapter 4:“PH (Save To
Disk - Hibernate)” on page 4-18)
.
Summary of Contents for 4200 San Marino
