9
SELV (Safety Extra Low Voltage) (Protection class III)
ECE test mark
Read the operating
instructions
6. OPERATING INSTRUCTIONS
6.1 OVERVIEW
E
24
1. Camera with IR LEDs and
connection cable
2. Monitor connection cable
for 12 V vehicle socket
3. Monitor
4. Cable tie
5. Bolts
Figure 1: Overview
6.2 INSTALLATION
These instructions are only valid as an example
due to the various vehicle types and cannot be
directly used for every vehicle.
6.2.1 CHECKING THE CAMERA SYSTEM BEFORE INSTALLATION
Check the function before installation. Proceed as follows: Plug the
camera cable and the transmitter cable together. Attach the plus
and minus cables of the transmitter to your vehicle battery (or other
suitable 12 V power source). Connect the monitor to the monitor
connection cable and plug this cable into your 12 V vehicle socket.
The picture appears and the camera can be installed. If no picture
appears, check the setup using the table in section 6.5.
6. Nuts
7. Clamp connectors
8. Gasket
9. Camera holder
10. Monitor holder
11. Transmitter with connection cable
6.2.3 REMOVING THE REAR NUMBER PLATE
First remove the rear number plate and, if present, also the number
plate holder of your vehicle.
Check whether there are cables, wires or other
components located at the position selected, which
could be damaged by the drilling.
6.2.4 PASS THROUGH FOR THE CAMBER CABLE
If there is no opening behind the number plate that can be used for
passing through the camera cable, you must drill a 10 mm diameter
hole to lay the cable in the interior. In this case fi rst remove the interior
lining of the boot.
When the hole for the cable to pass through has been drilled,
protect the bare areas of the sheet metal with rust protection paint or
other suitable paint.
6.2.5 MOUNTING THE CAMERA
Connect the camera to the camera holders, item 9 in the overview,
refer to Figure 2. For this use the bolts, item 5 in the overview and the
nuts, item 6 in the overview. Do not tighten the bolts yet. Place the
number plate or the number plate holder on the camera holders. Align
the camera holders so that the fastening holes of the number plate or
the number plate holder can be used. During this both number plate
holders must be no further apart than 4 cm, Figure 3.
6.2.2 CHECKING THE INSTALLATION LOCATION FOR SUITABILITY
Before you start with the installation, check whether the location
chosen is suitable for installation of the rear view camera. Therefore
hold both camera holders (item 9 in the overview), as precisely as
possible over the rear license plate. The number plate and the number
plate lighting must not be covered by the camera. The camera and
the holder must not block the boot during closing. The camera can be
mounted over or under the number plate. The camera must be moun-
ted so that the cable connection is located above.
Figure 2: Mounting the camera
Figure 3: Camera holders spacing
max. 4 cm
Now tighten the bolts.
The gasket, item 8 in the overview, has a collar on one side. This collar
must later lie on the outside of the vehicle metal. Now insert the
camera cable through the gasket from the collar side. Now insert the
camera cable with the gasket through the hole behind the number
plate. Set the number plate or the number plate carrier on the camera
holders and mount this combination back on your vehicle.
Complies with EC
directives
Labelled electrical
products may not be
disposed of in the
household waste
5. SYMBOL EXPLANATION
Summary of Contents for 16256
Page 2: ...2...