10
Figure 4: Inserting the cable
Figure 5: Pressing in the small
contact plates
Figure 6: Closing the
safety clamp
6.2.6 CONNECTING THE CAMERA
Select a suitable installation location for the transmitter, item 11
in the overview. Here it is possibly necessary to remove parts of the
lining in the boot or in the passenger compartment of the vehicle.
The installation location must not be too far removed from the
camera and the rear light, pay attention to the cable lengths. In
addition the transmitter must be placed as close as possible to the
receiver (monitor), without metallic components, body metal, ribs
and reinforcements being able to negatively infl uence the radio
transmission. Fasten the transmitter, e.g. with cable ties. Lay the cable
so that it cannot be bent, pinched or stretched.
Disconnect the battery. Look for the positive and negative cable for
the backup light. Connect the red positive cable of the transmitter
with the aid of the clamp connector. Item 7 in the overview, with the
positive cable of the backup light. Connect the black negative cable of
the transmitter to the negative cable of the backup light. Proceed as
shown in Figures 4 to 6.
For the next step, working on the electrical system of
the vehicle, it is necessary to unclamp the battery. This
could cause, for example, the radio code, data of the
on-board computer or other settings to be lost. To do this,
read the user‘s manual of your vehicle or ask the vehicle
manufacturer.
If you are unsure during the electrical installation, ask a
specialist workshop for advice.
There is a risk of personal injury and property damage.
Positive cable
Backup light
Positive cable
Transmitter
Fasten the monitor with the holder on the windscreen of your vehicle,
as shown in Figures 9 and 10.
Connection slot
6.2.7 MOUNTING THE MONITOR
Insert the monitor fi xture of the monitor holder, position 10 in the
overview, see Figure 7, in the recess on the back of the monitor.
Slide the monitor completely on the fi xture, until the lock engages.
Insert the angle plug of the monitor connection cable, item 2 in the
overview, in the connection socket of the monitor, Figure 8.
Figure 7: Monitor holder
Figure 9: Setting the holder
Figure 8: Connection slot
Figure 10: Holder tight
Clamping lever
Fixing nut
Lock
Suction
foot
Monitor fi xture
Tab
6.2.6.1 CONNECTING THE CAMERA ON VEHICLES WITH CAN
BUS OR DATA BUS SYSTEM
For vehicles with CAN bus or other data bus systems, it may be
necessary to connect the transmitter using a 12 V working current
relay (not included in the scope of delivery).
Connect the transmitter with the help of the working current relay
according to sketch 1.
backup
lamp
Mass
Mass
to Camera
Permanent plus battery
Relay
Transmittler
Sketch 1: Connection working current relay
CAUTION
Summary of Contents for 16256
Page 2: ...2...