Eton CXL-150 - SERVICE, Service Manual

Page: 9 / 111

2.9 DRIVE CHAIN
Stop the ATV and shift the transmission into neutral.
Measure the drive chain slack midway between the
sprockets.
Chain slack =15~25mm (5/8~1 inch)
Adjust the chain slack.
Loosen the lock nuts and turn drive chain adjusting nuts
until get the correct slack.
Tighten the axle holder bolts.
Torque = 90N.m (65 lbf.ft)
If your ATV has the tensioner inside the drive
chain. You don't need to follow the procedure
of chain slack adjustment. The drive chain will
be adjusted by tensioner.
When the drive chain becomes very dirty, it should be
removed, cleaned and lubricated by specify lubricator.
Using commercial chain lubricant to lubricate the drive
chain.
Clean the drive chain with kerosene and wipe it dry.
Inspect the drive chain for possible wear or damage.
Replace the chain, if it is worn excessively or damaged.
Inspect the sprocket teeth, if it is excessive wear
or damage, replace it.
2.10 BRAKE SYSTEM
Inspect the front brake lever and cable for excessive
play or other damage.
Replace or repair if necessary.
Measure the free play of the brake lever at the end of the
brake lever.
The standard of free play is 15-25 mm.
(The right side picture is for YXL 150)
9