EtherWAN EX26262, Management Manual

Page: 163 / 326

– 163 –
C
HAPTER
4
| Configuring the Switch
Link Layer Discovery Protocol
LLDP also defines how to store and maintain information gathered about
the neighboring network nodes it discovers.
C
ONFIGURING
LLDP
T
IMING AND
TLV
S
Use the LLDP Configuration page to set the timing attributes used for the
transmission of LLDP advertisements, and the device information which is
advertised.
P
ATH
Advanced Configuration, LLDP
P
ARAMETERS
These parameters are displayed:
LLDP Timing Attributes
◆
Tx Interval – Configures the periodic transmit interval for LLDP
advertisements. (Range: 5-32768 seconds; Default: 30 seconds)
This attribute must comply with the following rule:
(Transmission Interval * Transmission Hold Time)
≤
65536,
and Transmission Interval
≥
(4 * Transmission Delay)
◆
Tx Hold – Configures the time-to-live (TTL) value sent in LLDP
advertisements as shown in the formula below. (Range: 2-10;
Default: 3)
The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
TTL in seconds is based on the following rule:
(Transmission Interval * Transmission Hold Time)
≤
65536.
Therefore, the default TTL is 30*3 = 90 seconds.
◆
Tx Delay – Configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables.
(Range: 1-8192 seconds; Default: 2 seconds)
The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
This attribute must comply with the rule:
(4 * Transmission Delay)
≤
Transmission Interval
◆
Tx Reinit – Configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down. (Range: 1-10 seconds;
Default: 2 seconds)
When LLDP is re-initialized on a port, all information in the remote
system’s LLDP MIB associated with this port is deleted.
LLDP Interface Attributes
◆
Port – Port identifier.