48
V.1.0
troubleshooting
troubleshooting
Before contacting your after-sales service, perform the following basic checks. If you cannot solve the
problem by following the instructions below, contact your store’s after-sales service.
Problem
Cause
Solution
Smoke emitting from
ventilation openings during
baking process.
•
Some ingredients or oil
adhering to the heating
element or the nearby area.
•
Unplug the appliance, let it cool down
completely and clean the heating element
( Cleaning and care). Let it dry
completely.
Bottom crust of bread is
too thick.
•
Bread was kept warm for too
long so that it lost too much
moisture.
•
Take bread out of the appliance directly
after the baking process without keeping
it warm.
The bread pan is difficult
to be removed from the
appliance.
•
The bread pan is locked
•
To remove the bread pan from the
appliance, turn it anticlockwise to
unlock it (UNLOCK
).
It is very difficult to take the
bread out/kneader cannot
be removed from bread
pan.
•
Kneader is sticking to the
shaft in the bread pan.
•
Remove the bread around the kneader.
Then put hot water into the bread pan so
that the kneader is submerged. Wait for
10 minutes, then take the kneader out and
clean it ( Cleaning and care).
Ingredients are not kneaded
evenly and bread
is baked badly.
•
Selected mode is unsuitable
for ingredients.
•
Cover was opened frequently
during operating process.
•
Stir resistance is too large, so
that kneader cannot knead
properly.
•
Select an appropriate mode for your
ingredients.
•
Do not open the cover during operation,
especially during the last rising process.
•
Take the bread pan out and operate the
appliance without load. If the kneader
gears turn normally, add some liquid to
your dough to remove resistance. If they
don’t turn normally, contact an authorized
service facility for repair.
“HHH” is shown on
display after pressing
“Start/Stop” button.
•
Appliance is still hot from a
previous operating process.
•
High ambient temperature.
•
Turn off and unplug the appliance. Take
the bread pan out, open the lid and let the
appliance cool down 10-20 minutes.
•
Transfer the appliance to a cooler place
(15°C - 34°C.).
«EEE» is shown on display
after pressing “Start/Stop”
button.
•
Defective temperature sensor.
•
Contact an authorised service facility.
Motor noises can be heard,
but dough isn’t kneaded
•
Bread pan is not properly
locked in place.
•
Amount of dough is too large
to be kneaded
•
Lock bread pan in place properly.
•
Check dough and remove some of it, if
necessary.
Summary of Contents for EMP1104
Page 2: ...1 V 1 0 1 7 6 2 3 4 5 8 9 11 10 14 13 12 15 17 16...
Page 89: ...88 V 1 0...
