Esaote MyLabOmega, Getting Started

Page: 50 / 118

S Y S T E M O V E R V I E W
MyLab
- G E T T I N G S T A R T E D 3 - 16
Error #3
This error indicates that one battery couldn’t be charged. The system displays
the following message:
If this situation occurs, close the exam as soon as possible by pressing
EN D
EXAM
and switch the system off by pressing
O N /O FF
and then the main switch
placed on the rear panel. Switch
MyLab
on again and check whether the
message is still present. If the problem persists, contact Esaote personnel.
Error #4
This error indicates that at least one of the batteries has reached the maximum
temperature allowed for its working conditions. The system displays the
following message and shuts down automatically:
Should this situation occur, contact Esaote Service.
Power Supply Error Messages
Whenever an error in the management of the power supply occurs, the
system displays a numbered error message: the number in the warning
message indicates the type of error.
Error #5 This error indicates an overheating problem of the power supply. The system
displays the following message:
If this situation occurs, shut down the system and leave it off for a while.
Verify that there is adequate ventilation to prevent the overheating of the
device.
Should the problem persist, contact the Esaote Service department.
Error #6
This error indicates that a fan is not working. The system displays the
following message:
Error #3: problem with battery
charging
.
Error #4: problem with battery status.
The automatic shut down will start in a
few seconds.
Error #5: overheating!
Please, contact the Service department.
Error #6: problem with fan.
Please, contact the Service department.