ero electronic MKC, User Manual, Page: 79 / 141

Gr.1
75
RUN TIME PARAMETER MODIFICATION.
By “MENU” push-button it is possible to start the run time
parameter modification by selecting desired run time parameter
group.
During the run time parameter modification, the upper display
shows the selected parameter group, the lower display shows
the mnemonic code of the selected parameter while the central
display shows the value or status assigned to the selected
parameter.
The parameter monitoring and modification are subjected to a
time out (see “t.out” [C.I10] parameter) after that the display
returns in “Normal display mode” and the eventual modification
on the last displayed parameter will be lost.
NOTES :
1) In the following pages we will describe all the parameter of
the instrument but it will show only the parameters related
with the specific hardware and in accordance with the specific
instrument configuration.
2) If all the parameters of a group are not available, the
instrument will not display this group.
3) For an easy consultation of the manual, it is accompanied by
a table with all the run time parameter visualization.
Run time group 1 [r.Axx]
Set point VALUES
- Main set point - [r.A01]
Range: from "rL" [r.E12] to "rH" [r.E13].
- Set point 2 - [r.A02]
This parameter is available only when one of the logic inputs is
configured for SP/SP2 selection
Range: from "rL" [r.E12] to "rH" [r.E13].
Xkc-1-C0.P65 5/29/02, 11:59 AM 75