ero electronic MKC, User Manual, Page: 33 / 141

29
CONFIGURATION MODE
Switch on the instrument.
The instrument will start in the same way it was prior to the
power down (configuration mode or run time mode)
If the instrument starts in configuration mode, push the MENU
pushbutton and go to the "Configuration group 1" (see page 30).
If the instrument starts in run time mode, by keeping depressed
the MENU push-button for more than 5 seconds the instrument
will show:
NOTES :
1) The upper display shows the selected parameter family.
2) The middle display shows the selected action.
3) The lower display shows the firmware version.
4) If no push-button is depressed for more than 10 s (or 30 s
according to "CnF.6" "t.out" [time out selection" C.I10]
parameter setting), the instrument returns automatically to the
normal display mode.
By
s
or
t
push-button it is possible to select between:
= (monitor) this selection allows you to monitor but
not to modify the value assigned to the configura-
tion parameters
= (modify) this selection allows you to monitor and
to modify the value assigned to the configuration
parameters.
NOTES :
1) During monitor mode, the instrument continues to operate as
in run time mode.
2) When modify mode is started, the instrument stops the
control and:
- sets control outputs to OFF;
- turns OFF the bargraph displays (MKC only);
- sets analog retransmissions to the retransmitted initial
scale value;
- sets alarms in no alarm condition;
- sets events to OFF;
- disables the serial link;
- the time out will be removed.
3) When the modify mode is disabled by V101 (V101.3), the
s
or
t
push-button pressure has no effect.
Xkc-1-C0.P65 5/29/02, 11:59 AM 29