Managing Hardware with CLI Commands
5-20
SmartEdge 1200 Router Hardware Guide
Table 5-25
Output Fields for the
show hardware
Command
Field
Description
Fan Tray Status
• Present—Fan tray is installed.
• Not Present—Fan tray is not installed or not working.
Fan(s) Status
• Failed—At least one fan is not working.
• Normal—All fans are working.
Power Supply A1 Status
Power Supply A2 Status
Power Supply B1 Status
Power Supply B2 Status
• No Power—Power has failed, is disconnected.
• Normal—Power is being supplied by this source.
Active Alarms
Alarm conditions for this unit:
• NONE—No alarm conditions exist.
• condition—Alarm condition is in effect.
For a complete list of conditions that can cause an alarm, see Appendix B, “Alarms and
Probable Causes.”
Slot
• slot—Slot number for this unit.
• N/A—No slot number for this unit.
Type
Unit:
• backplane—Backplane.
• fan tray—Fan tray is installed.
• traffic-card-type—Traffic card is installed; see Table 5-23 for a list of card types.
• controller-card-type—Controller card is installed; see Table 5-23.
Serial No
nnnnnnnnnnnnnn—Unique identifier for this unit; 14 alphanumeric characters. To
identify the model of the SmartEdge 1200 chassis using the serial number, see
Table 5-26.
Rev
n—Hardware revision level for this unit; single digit.
Ver
1
1. The EEPROM ID and version are displayed with the
show hardware
command with the
detail
keyword.
nnnn/n—Version of the unit EEPROM.
Mfg Date
dd/mm/yyyy—Date unit was manufactured.
Voltage
2
2. Readings for voltage sources are displayed with the
show hardware
command with the
detail
keyword along with the percentage over
or under the nominal value.
• N/A—Voltage is not applicable for this unit.
• NOT OK—Voltage for this card is outside its operating range.
• OK—Voltage for this card is within its operating range.
Temp
3
3. See Table 5-28 on page 5-24 for temperature definitions for each condition. Actual temperature reading in degrees Celsius is displayed
with the
show hardware
command with the
detail
keyword.
• Cold—Temperature is colder than normal.
• Extreme—Temperature is much hotter than normal.
• Hot—Temperature is hotter than normal.
• N/A—Temperature does not apply to this unit.
• Normal—Temperature is within normal operating range for this unit.
