CARDIO LINE 4000 S/S MED/MED/SP/S SP
CARDIO LINE 4100 S/S MED/MED
Technical and visual modifications as well as misprints reserved -
© 2018
by ERGO-FIT GmbH & Co. KG
WHO-Test:
3.
Now move to the parameter query „Start load“, „Step time“, „Load increase“ and
„Rest load“. You can increase / decrease the values by pressing PLUS and MINUS,
or you can manually enter them via the numeric panel. You can switch between the
different values by pressing the arrow keys or the Enter key, or you can manually
select a parameter. Change the gender by pressing the symbol button on the right
edge of the screen. Confirm the modifications with START. If a specification is out
of range, it will be marked red. Correct the specification and confirm with the START
button.
4.
When performing a test without chip card you can modify the workload by pressing
PLUS and MINUS. As soon as your heart rate exceeds the set maximum value the
test ends automatically after completion of the sequence and continues with cool
down. You can stop the test at any time by pressing the STOP button - in this case
test analysis is not possible. If you want to change the view during workout press
the blue arrow on the right below the heart rate and performance graphs. If you
want to toggle between graph and profile view (Test, Cool Down) use the PROFILE
and GRAPH buttons on the left below the heart rate and performance graphs.
5.
After the test is completed you will see the Test Results screen. Here you get a
summary of the test results. By pressing STOP again you return to the main
menu.
Test procedure with chip card:
⊗
PWC 130/150/170 (sub maximum test with a heart rate 130/150/170), CYCLE 4000
marked „S“ in combination with an ERGO-FIT training software only.
⊗
level test (sub maximum test with a heart rate 130/150/170), TRAC 4000 marked
„S“ in combination with an ERGO-FIT training software only.
⊗
Conconi-test (standard test for performance diagnostics), CYCLE and TRAC 4000
marked „S“ in combination with an ERGO-FIT training software only.
Please proceed as follows:
1.
The trainer selects the test. Then the chip card is initialized. You can now start the
test.
2.
Insert the initialized chip card into the card reader slot. When reading the chip card
the control panel automatically enters the TEST mode.
6 7
